Turn your HS-1 into a rod finishing/drying motor

ROD DRYING CHUCK KIT INSTRUCTIONS

STEP 1 Using a phillips screw driver, screw the 6 post sets from the RDC-RB Kit into the holes as shown. Do not over tighten.
	STEP 2 Double wrap the 3 rubber straps included with the RDC-RB Kit between the post pairs as shown.
STEP 3 Insert rod butt or tip section.
	STEP 4 You can use the HS-1 Box as a rod stand. With the box positioned as shown, cut a v-notch in the top on both sides approx. 3/4" deep. This is just about the perfect height for finishing rods with the HS-1.

STEP 1

Using a phillips screw driver, screw the 6 post sets from the RDC-RB Kit into the holes as shown.

Do not over tighten.

Head Spin RDC-RB Rod Drying and Finishing Kit

STEP 2

Double wrap the 3 rubber straps included with the RDC-RB Kit between the post pairs as shown.

STEP 3

Insert rod butt or tip section.

STEP 4

You can use the HS-1 Box as a rod stand.

With the box positioned as shown, cut a v-notch in the top on both sides approx. 3/4" deep. This is just about the perfect height for finishing rods with the HS-1.

ITEM	PURCHASE


Self Centering Self Adjusting Rod Drying Chuck kit Part# RDC-RB.......... $9.99

ROD DRYING CHUCK KIT INSTRUCTIONS